![]() Section 25.2 (General Reinforcement Requirements) ![]() If your wall does not meet a code requirement the program will give a red warning message in the detail report. Sections 25.2 and Chapter 11 have provisions regarding min/max spacing, required reinforcement ratios, and proper proportioning of wall reinforcement. If specific reinforcement is defined in the Wall Design Rules spreadsheet then it may be possible for the reinforcement design to not meet code requirements. For this design reinforcement spacing, rho, and strength requirements are considered for design. The program will design the reinforcement spacing for you. Concrete Design Considerations ACI 318-14/19 Reinforcement Design To exit this tool right-click your mouse. To manually draw regions, select the Design Wall Regions manually button and use your cursor to select two nodes or grid intersections which make up the diagonal corners of the region. To automatically generate regions prior to running a solution, click the Design Wall Regions Automatically button. If no regions have been drawn on a wall then they will be automatically generated when a solution is performed. Each region will be assigned a uniform reinforcement, which may be different than the reinforcement in other parts of the same wall (unless you are using Group Story option from Wall Design Rules). Regions are used to define reinforcement in different parts of the wall. Within each region, the program will optimize the spacing of bars for strength, spacing and minimum reinforcement considerations of the wall.įrom within the Wall Panel Editor, you have the option of creating rectangular regions within the concrete wall panel. If there are diaphragms that pass through your wall panel and/or there are openings in the wall, then the wall will be broken up into multiple regions above and below the diaphragms and around the openings, giving a different reinforcement design for each region. If you have a wall panel with no diaphragms then a single region will be created over the entire wall and you will get a single reinforcement design for the entire wall. The program automatically creates these regions at solution time. Concrete Wall RegionsĬoncrete walls depend on Regions for results presentation. The Wall Grid allows you to modify your snap options, drawing grid in the wall panel editor. The wall panel grid increment and snap points can be specified in the Drawing Tools section of the Walls tab.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |